Electric Connections - RIB KS2 Bedienungsanleitung

ELECTRIC CONNECTIONS

M1
*
1 -> S
2 -> +
3 -> GND
EXTERNAL SIGHT ENCODER
CONNECTOR
1
*
=> 1-2-3 are the plugs of the connector where you have to insert one side of the 3 WIRES (DO NOT CONNECT THE SHIELD)
=> S, +, GND are the plugs of the control board where you have to insert the other side of the 3 WIRES. The SHIELD must be connected to the
3
2
INTERNAL SIGHT
WIRING ENCODER CONNECTOR
1 -> V
2 -> W
3 -> U
->
Where:
EARTH from the power supply (not to GND).
WARNING!
The length of connection cables from the motors to the control panel unit must not exceed 15 m.
The wire section of the motor power supply must be 1.5 mm
mm .
2
As for the encorder it is very important to use a shielded wire with a section of 0,75 mm
ÖLFLEX-110 CH - code ACG2133).
It is compulsory to use shielded cable for the encoder in order to guarantee the correct operation of the
control board.
To ensure the correct functioning of the installation it is advisable to wire encoder and motor with separate
cables.
M2
17
KS2 code BC07048
, whilst that of the accessories must be 0,75
2
2
G
B
(Ex: type