PeakTech 4105 Bedienungsanleitung Seite 87

4.3.10 To output a Frequency Sweep
If you want to output an swept waveform with sweep time of 5 second, logarithmic sweep,
1. Select Frequency sweep
Press 【Sweep】key and then verify that the Frequency Sweep is selected in default.
2. Select sweep time
Press the 〖Sweep Time〗softkey then set the value to 5s using the numeric keypad or the
knob and arrow keys.
3. Select sweep mode
Press the 〖Mode Line/Log〗softkey and then verify that the logarithmic sweep mode is
currently selected on the first softkey.
4.3.11 To output a Burst waveform
If you want to output a five-cycle wave with a 10ms burst period, continuous or manual
signal trigger.
1. Press 【Burst】key then burst menu is shown in the screen of the current channel.
2. Press 【Burst Mode】 and select the 'Triggered'.
3. Press 〖Burst Period〗softkey then set the value to 10ms using the numeric keypad or
the knob and arrow keys.
4. Press 〖Cycle Count〗softkey then set the value to 5 using the numeric keypad or the
knob. Press the 〖Ok〗 softkey to finish data entry if you are using the numeric keypad.
At this point, the waveform generator outputs a continuous five-cycle burst at 10 ms intervals.
You also can generate signal burst (still with 5 cycles) by pressing 〖Source Int/Ext〗softkey and
select External to disable above setting output. Then each time
you press 〖Manual Trig〗softkey, one five-cycle burst will be output. Press number depends on the
desired burst number.
86