PeakTech 4105 Bedienungsanleitung Seite 117

5.13.5 Bursts
Make use of waveform combine feature, the waveform generator can output some special
waveforms. For example, couple two-cycle bursts with high frequency on CHB. You can operate as
following steps:
(1) Enable CHA to be continuous, 10kHz Square with duty cycle 10%.
(2) Enable CHA to be burst again, burst period 1ms and burst count 2.
(3) Press 【Dual Channel】key and set the amplitude combine to be 50%.
(4) Press 〖Combine On/Off〗softkey then select On.
(5) Enable CHB to be continuous, 1kHz Sine.
(6) Then a Sine with two-cycle bursts output from CHB connector.
5.14 Arbitrary Waveform
Press 【Utility】key then 〖Arb Edit〗softkey, then edit window and menu appears.
5.14.1 Edit Window
You can edit some simple waveforms by keypad through this edit window. The horizontal axis stands
for phase with range 0 to 4095 and output phase 0°to 360. And vertical axis presents for amplitude
voltage with range 0 to 16383 and output voltage -10V to +10V. Press 【Waveform】 key to select one
of 60 waveforms (take a Sine for example) then return. The selected waveform will be displayed in
the edit window for user to edit and modify.
116