PeakTech 4105 Bedienungsanleitung Seite 125

5.16.4 Screen protect
Press 〖Screen Protect〗softkey to select 'Scrn pro' to set the time of screen protection. If no panel
operation lasts a certain time as set, the screen will light off automatically to save source and screen
aging, and longer generator's working life. Press any key to resume screen display.
5.16.5 Beeper
When you press a front-panel key or turn the knob, the waveform generator will emit a short tone. If
you want to disable the beeper for certain applications, press 〖Beeper On/Off〗 softkey then to select
'Off' to turn off the beeper. A long beeper tone will be emit when an error is generated from
front-panel operation.
5.16.6 Baud Rate
Press〖Baud Rate〗softkey then select 'Baud Rate' to configure the baud rate of RS-232. There are
six configurations for selecting: 2400, 4800, 7200, 9600, 14400 and 19200. Make sure that the baud
rate of device connected with the generator should be same as setting of waveform generator to
realize the normal communication.
5.17 Color Configuration
Press 【Utility】key then to 〖Color Config〗softkey to configure the color of the system.
5.17.1 Set color of CHA font
Press 〖Chanl A Font〗softkey then select 'CHA Font' to choose the desired color for CHA font.
5.17.2 Set color of CHB font
Press 〖Chanl B Font〗softkey then select 'CHB Font' to choose the desired color for CHB font.
124