PeakTech 4105 Bedienungsanleitung Seite 112

5.11.3 Start Number and Stop Number
Press 〖Start Number〗or〖Stop Number〗softkey to select the desired number. In the frequency list
sweep mode, the waveform generator moves from the start number, output each frequency value
contained in a list one by one, until to the stop number.
5.11.4 Dwell Time
After enabling sweeps, press 〖Dwell Time〗 softkey. Then use the knob or numeric keypad to enter
the desired dwell time. The dwell time specifies the number of seconds to remain at each frequency
point.
5.11.5 Hold Time
After enabling sweeps, press 〖Hold Time〗 softkey. Then use the knob or numeric keypad to enter
the desired hold time. The hold time specifies the number of seconds to remain at the stop number.
5.11.6 Sweep Trigger Source
Same as frequency sweep. See 3.10.8 sweep trigger source.
5.12 Burst Output
You must enable burst before setting up any of the other burst parameters. Press 【Burst】 key to
output a burst using the present settings for frequency, output amplitude, and offset voltage.
111