PeakTech 4105 Bedienungsanleitung Seite 124

5.16.1 Display Mode
Press 〖Display Mode〗softkey. If 'Single CH' is selected, only one channel's information
are shown in display area and 10 parameters at most. Press 【CHA/CHB】to see the other channel's
information.
If 'Dual CH' is selected, the display area is divided into two parts and can display the two channels at
the same time. But only 5 parameters of each channel can be shown. Press 〖More〗softkey to see
the rest parameters.
5.16.2 Cursor Mode
Press 〖Cursor Mode〗softkey then select 'Auto' to configure the auto mode. When the cursor are
located in leftmost of parameter, rotate the adjusting knob right to add the digit on the cursor
position by 1, it can do a carry to the former; rotate the adjusting knob left to subtract the
digit on the cursor position by 1, it can borrow digit from the former . It's more convenient to
adjust parameter within wide range using cursor auto mode. But make sure that the cursor
must be located in leftmost of parameter. Otherwise, it's same as manual mode.
If 'Manual' is selected, the cursor shift by use of manual mod e no matter where the cursor in.
And it will be more convenient if parameters allow to be used positive and negative value.
5.16.3 Power-on State
You can store the regular parameters of power-on state to 1# location, then press 〖Power on State〗
softkey to select 'User Def'. Once power on, the waveform generator will automatically recall the
power-on state in 1# memory location. Every time you power on the generator, the power-on state
will be the same.
If select 'Last', the waveform generator will store the present state to 1# location, which will be
recalled automatically next time you power on the generator, namely, the state of last operation.
Therefore, every time you power on the generator, the power-on state will be different.
123