PeakTech 4105 Bedienungsanleitung Seite 83

4.3 Basic Operation
4.3.1 To select the output channel
Press 【CHA/CHB】key to open desired channel configuration screen. Note th at fonts of
channel name, mode and waveform were indicated by green color. Use softkeys together
with knob or numeric keypad to set the waveform and parameters of desired channel.
Enable or disable the output signal of desired channel by pressing 【Output】key.
4.3.2 To select a waveform
Press 【Waveform】key to see the first page of the list, and then press 〖More〗softkey to
see the rest of the list. There are sixty waveforms type in total, and select one desired in
sixty to see the waveform diagram under Cont inuous mode.
4.3.3 To set duty cycle
For example, specify a duty cycle of Square to 20%.
Press 〖Duty Cycle〗softkey and then set the duty cycle to 20% using the numeric keypad
or the knob and arrow keys 【<】 【 >】. If you use the keypad, press 〖％ 〗 softkey to finish
entering the value.
82