PeakTech 4105 Bedienungsanleitung Seite 122

5.15.1 Status store
The setting for the instrument, such as waveform, frequency and amplitude, are commonly named as
instrument state parameters. The internal of instrument are divided into 5 non-volatile areas and can
store 5 group state parameters.
Press〖Status Store〗softkey then select 'Store' to save current state to specified non-volatile
locations, which won't be lost even turn off the power.
But store a new group of state parameters will cover the previous state setting. In order to protect the
previous state, the waveform generator will pop up a prompt 'Will cover original data, Store?' Only
press 〖Yes〗softkey to enable the store. Otherwise, to press 〖Cancel〗softkey.
Press 〖Status Store〗softkey and display 5 memory location,〖Default State〗,〖Power On State〗,
〖 User 0 State〗, 〖 User 1 State〗and〖User 2 State〗. Press any one of five to store present state
to appointed location. The 'Store' will show after finishing store.
〖Default State〗 location store the factory default state, to prevent it from damage, state storage can't
be allowed in〖Default State〗.
〖Power On State〗location store the state when instrument power on. User can store the common
states to this location, which will be recalled automatically when power on the generator.
The memory location of〖 User 0 State〗,〖 User 1 State〗and〖User 2 State〗can be used to store
three group customization states for special use.
5.15.2 Recall State
Press 〖Status Recall〗softkey and select 'Recall' to recall the state parameters from appointed
non-volatile area. Press 〖Status Recall〗softkey then display 5 memory locations just same as store
state. Press any one of five to recall the relative state. After finishing recall, the display interface
converts to continuous mode and the instrument work under new mode.
121