Troubleshooting; Technical Data - Cleanmaxx WE-803-C Gebrauchsanleitung

troubleshooting

If the device is not working properly, please check first of all whether you can rectify a problem
yourself. Otherwise you should contact the customer service department.
Do not attempt to repair a defective device yourself!
Problem
The device does not
work.
Low suction force.
Dust escapes from the
device during cleaning.

technical Data

Device
Model:
Article number:
Voltage supply:
Power:
Battery charging time:
Battery operating time:
Mains adapter
Model:
Voltage supply:
Output:
Protection class:
08314_DE-GB-FR-NL_V0.indb 24
Possible cause / solution
• Is the battery flat? Recharge it.
• Is the device switched on? Press the On / Off switch.
• Is the collecting container full? Empty it in the manner
described in the "Device Cleaning and Storage" chapter.
• Is the filter heavily clogged up? Clean it in the manner described
in the "Device Cleaning and Storage" chapter.
• Is the suction opening blocked? Switch off the device and
remove the blockage.
• It is also possible that some smaller items will remain stuck
to the carpet or will be too big / heavy to be picked up by the
device.
• Check whether the dust container and the filters are inserted
correctly. Correct their position if necessary.
WE-803-C
Z 08314
12 V DC, 1200 mAh
100 W
approx. 10 hours (The first charge lasts 24 hours.)
approx. 30 minutes
WJG-Y41180400D
220–240 V~, 50 Hz
18 V DC, 400 mA
II
24
10.12.12 17:16