Troubleshooting - Cleanmaxx 01169 Gebrauchsanleitung

EN
Emptying the dust bin and cleaning the fi lter
1. Carefully take the dust bin out of the motor unit (see chapter "Assembly" – "Remov-
ing / inserting the dust bin").
4. Allow all parts to air dry completely before assembling them. PLEASE NOTE: Do
not in any case put the fi lter back in place if they are still wet. Reverse the steps
to assemble them.

Troubleshooting

If the device is not working properly, please check whether you are able to rectify the
problem yourself fi rst. If the problem cannot be solved with the steps that are listed,
contact the customer service department.
Do not attempt to repair a defective device yourself!
Problem
The device only
operates slowly or
doesn't start.
The suction power is
weak.
The device
emits dust when
vacuuming.
The charge control
light doesn't
illuminate when the
device is connected
to the mains supply.
01169_01279_01578_02223_04380_05784_08862_DE-EN-FR-NL_A5_V8.1.indb 22 01169_01279_01578_02223_04380_05784_08862_DE-EN-FR-NL_A5_V8.1.indb 22
22
2. Pull the fi lter out of the dust bin.
3. Clean the dust bin and the fi lter:
– If you have sucked up dry dirt, empty the dust bin over
a rubbish bin. Tap out the fi lter. Then wipe them down
using a damp cloth.
– If there is wet dirt in the dust bin, rinse these parts
under running water.
Potential cause / solution
• Is the battery empty? Charge up the battery.
• Is the battery too weak? Charge up the battery.
• Is the dust bin full? Empty the dust bin.
• Is the fi lter heavily laden with dirt? Clean it as described in
chapter "Cleaning and Storage".
• Is the suction opening / nozzle plugged? Turn off the device
and remove the blockage.
• It is also possible that some particles are too large / heavy
for the device to vacuum up.
• Check whether the dust bin and fi lter have been properly
inserted and if necessary, adjust their seating.
• Is the fi lter heavily contaminated? Clean it in accordance
with the "Cleaning and Storage" chapter.
• Is the fi lter worn or damaged? Order a new fi lter via
www.dspro.de/kundenservice and replace it.
• Is the mains adapter properly connected with a socket and
is the barrel plug connected with the connector jack of the
device?
• Is the socket defective? Try another socket.
• Check the fuse for your mains connection.
09.11.2021 17:21:28 09.11.2021 17:21:28