Additional Safety Instructions; Residual Risks - Parkside PWSA 12 B1 Originalbetriebsanleitung

ting. Otherwise, the disc may
catch, spring away from the
workpiece or cause a kick-
back.
e) Support plates or workpieces
to reduce the risk of kickback
from a jammed cutting disc.
Large workpieces may bend
under their own weight. The
workpiece must be supported
on both sides of the disc,
near the cutting disc as well
as also at the edge.
f) Be particularly careful for
pocket cuts in existing walls
or other areas where you
cannot see what is there. The
cutting disc may cause a kick-
back when it cuts into gas or
water lines, electrical lines or
other hidden objects.
Additional safety
instructions
• Only use grinding discs
where the indicated rotational
speed is at least as high as
what has been specified on
the name plate of the device.
• Carry out a visual inspection
of the grinding disc before use.
Do not use any damaged or
deformed grinding discs. Re-
place any damaged or worn
grinding discs.
• Make sure that the sparks
produced by grinding do not
present a danger, e.g. reach
people or ignite flammable
substances.
• Always wear safety goggles,
safety gloves, respiratory pro-
tection and ear protection
when grinding, brushing and
cutting.
• Never keep the fingers be-
tween the grinding disc and
spark protection or in close
proximity to the protective
hoods. There is a risk of
crushing.
• The rotating parts of the de-
vice cannot be covered due
to functional reasons. There-
fore, proceed cautiously and
hold the workpiece firmly in
order to avoid slipping which
could cause your hands to
come into contact with the
grinding disc.
• The workpiece gets hot dur-
ing grinding. Do not touch
the machined area, allow it
to cool down. There is a risk
of burning. Do not use cool-
ants or the like.
• If you are tired or have con-
sumed alcohol or tablets, do
not work with the device. Al-
ways have a break on
• Turn off the device and re-
move the battery from the
device before servicing the
device.

RESIDUAL RISKS

Even if properly operating and
handling this electric tool, some
residual risks will remain. Due
to its construction and build, this
electric tool may present the fol-
lowing hazards:
a) Lung damage if suitable
respiratory protection is not
worn.
GB IE
time..
35