Wellsystem Relax_Plus Gebrauchsanweisung Seite 74

03/2011 1009864-00
Operating Settings /
button Display
Altering the nozzle
carriage speed,
e.g. from
to
Altering the back length,
e.g. from
to
Altering the massage area and the type of massage
NOTE:
The zone or point massage selection only functions when
the nozzles are moving from the head end to the foot end.
If you have missed the right moment:
•
First select whole body massage again.
•
Wait until the nozzles reach the desired position while
moving from the head end.
•
Press zone or point massage.
– Press the new massage area button.
– Press the new massage type button.
Massage area default factory setting: Whole body
Massage type default factory setting: Parallel stroke
Remarks
Press the speed button and hold
down for approx. 1 s The display will
flash. Press the plus or minus buttons
to set up the value that you want.
Factory setting: SP.15
Minimum and maximum speeds:
05 to 30 in increments of 1
Press the back length button and hold
down for approx. 1 s Display flashes.
Press the plus or minus buttons to set
up the value that you want.
Factory setting: 55
Steps: 45, 55, 65
Operating instructions – 27
Operation