Contents
1 Introduction ....................................................................... 3
2 Safety ............................................................................... 5
3 Installation ......................................................................... 6
5 Applications .................................................................... 14
8 Safety manual ................................................................ 22
1 Introduction
1.1 General
This document provides basic instruction for the installation and
commissioning of the ABB 2600T pressure transmitter. This
transmitter is connected to a process by means of impulse lines and
can measure Pressure, Differential pressure or Absolute pressure.
The measurement is transmitted to a control system by means of a
4-20 mA signal with a superimposed digital signal (Hart) or by means
of a digital transmission protocols (PROFIBUS or FOUNDATION
Fieldbus).
The measure can also be indicated by means of one of the
(optional) local or remote displays. Instructions for preliminary
checks, proper transmitter location, installation, wiring,
power-up and zero calibration (trimming) of the transmitter are
listed in the following chapters. In order to assure operator and
plant safety it is essential that the installation is carried out by
personnel suitably trained on the local applicable codes on
hazardous location, functional safety, electrical wiring and
mechanical piping.
Please read these instructions carefully before installing the
transmitter. The protection provided by the equipment may be
impaired if the equipment is used in a manner not specified.
1.2 Supplementary documentation
For further information, please refer to the following documents:
DS/266XX_X
Pressure Transmitter Datasheets
DS/S26
Remote Seal Datasheet
IM/266
266 Pressure Transmitter Instruction Manual
IM/S26
Remote Seal Instruction Manual
All the addendum and other documents downloadable from
www.abb.com/pressure
1.3 Use of instructions
Danger - <Serious damage to health/risk to life>.
message indicates that an imminent risk is present. Failure
to avoid this will result in death or serious injury.
Caution - <Minor injuries>.
dangerous situation. Failure to avoid this could result in minor
injuries. This may also be used for property damage warnings.
Important.
particularly useful information. It does not indicate a dangerous or
damaging situation.
Warning - <Bodily injury>.
dangerous situation. Failure to avoid this could result in death or
serious injury
Attention - <Property damage>.
potentially damaging situation. Failure to avoid this could result in
damage to the product or its surrounding area.
Although Warning hazards are related to personal injury, and
Caution hazards are associated with equipment or property
damage, it must be understood that operation of damaged
equipment could, under certain operational conditions, result in
degraded process system performance leading to personal
injury or death. Therefore, comply fully with all Warning and
Caution notices.
1.4 Health and safety
To ensure that our products are safe and without risk to health,
the following points must be noted:
- The relevant sections of these instructions must be read
carefully before proceeding.
- Warning labels on containers and packages must be
observed.
- Installation, operation, maintenance and servicing must
only be carried out by suitably trained personnel and in
accordance with the information given. Any deviation from
these instructions, will transfer the complete liability to the
user.
- Normal safety precautions must be taken to avoid the
possibility of an accident occurring when operating in
conditions of high pressure and/or temperature.
- Chemicals must be stored away from heat, protected from
temperature extremes and powders kept dry. Normal safe
handling procedures must be used.
- When disposing of chemicals ensure that no two
chemicals are mixed.
Safety advice concerning the use of the equipment described
in this manual or any relevant hazard data sheets (where
applicable) may be obtained from the Company address on the
This
back cover, together with servicing and spares information.
This message indicates a potentially
This message indicates indicates operator tips or
This message indicates a potentially
This message indicates a
2600T Series Pressure transmitters | SOI/266-XC Rev. D 3
1 Introduction