Safety - ABB 2600T-Serie Bedienungsanleitung

2 Safety

2.1 General
Read this instruction carefully prior to installation and
commissioning. For reasons of clarity, the instructions do not
contain all details on all types of product and do therefore not
take into account every conceivable case of assembly,
operation or maintenance. If you want further information or if
special problems arise which are not treated in detail in the
instructions, please ask the manufacturer for the necessary
information.
Moreover we would like to point out that the content of these
instructions is neither part of nor provided for changing a
previous or existing agreement, promise or legal relationship.
All obligations of ABB Instrumentation result from the respective
sales contract which also comprises the complete and solely
valid warranty clauses. Such contractual warranty clauses will
neither be limited nor extended by the content of these
instructions.
Observe warning signs at packaging, etc.
For assembly, electrical connection, commissioning and
maintenance of the transmitter, only qualified and authorized
specialists are to be employed, because they are experienced
in the assembly, electrical connection, commissioning and
operation of the transmitter or similar devices holding the
necessary qualifications for their job, e.g.:
— Training or instruction and/or authorization to operate and
maintain devices/systems according to the safety
engineering standard for electric circuits, high pressures
and aggressive media.
— Training or instruction according to the safety engineering
standard regarding maintenance and use of adequate
safety systems.
For the sake of your own safety, we draw your attention to the
fact that for the electrical connection, only sufficiently isolated
tools acc. to EN 60 900 may be used.
Furthermore consider the following regulations:
— The pertinent safety regulations concerning the
construction and operation of electrical installations, e.g.
the rule regarding technical working material (safety rule
for instruments), have to be observed.
— The pertinent standards.
— The regulations and recommendations relating to
explosion protection if explosion-proof transmitters are to
be installed.
— The safety raccomandation if installed in a SIL loop as
described in the Safety Manual (please look at the end of
this manual)
The device can be operated with high pressure and aggressive
media. Serious injury and/or considerable material damage can
therefore be caused when this device is handled incorrectly.
Please observe the pertinent national rules when using pressure
transmitters.
2.2 Transportation
After final calibration, the instrument is packed in a carton
intended to provide protection from physical damage.
2.3 Handling
The instrument does not require any special precautions during
handling although normal good practice should be observed.
2.4 Storage
The instrument does not require any special treatment if stored
as dispatched and within the specified ambient conditions.
There is no limit to the storage period, although the terms of
guarantee remain as agreed with the Company and as given in
the order acknowledgement.
2600T Series Pressure transmitters | SOI/266-XC Rev. D 5
2 Safety