Installation - Fenix 200 Bedienungsanweisung

RISKS DUE TO ELECTROMAGNETIC
FIELDS

The magnetic field generated by
the machine can be dangerous to
people fitted with pace-makers, hearing aids
and similar equipment. Such people must con-
sult their doctor before going near a machine in
operation.

Do not go near a machine in operation with
watches, magnetic data supports and timers etc.
These articles may suffer irreparable damage
due to the magnetic field.

This equipment complies with the set protection
requirements and directives on electromagnet-
tic compatibility (EMC). Welding machine is
from the term of interference is design for
industrial premises - Classification according to
IEC 55011 (CISPR-11) Group 2, Class A. It is
expected their widely used for all industrial
areas, but is not intended for home use. In case
of use in other areas than industrial, there
might be need special measures required (see
DIN EN 60974-10).
electromagnetic disturbances it is the user's
responsibility to solve the given situation.
WARNING!
This Class A device is not intended for use in
residential locations where the electrical energy is
supplied by low voltage system. In these areas may
be problems with
compatibility caused by interference caused by
power lines as well as radiated disturbance.
MATERIALS AND DISPOSAL

These machines are built with
materials that do not contain
substances that are toxic or poi-
sonous to the operator.

During the disposal phase the machine should
be disassebled and its components should be
separated according to the type of material they
are made from.
DISPOSAL OF USED EQUIPMENT

For the disposal
equipment use the collection
points for the abstraction used
elektrical equipment (seat the manufacturer).

The equipment used to dispose of household
waste and follow the steps listed above.
HANDLING AND STOCKING COM-
PRESSED GASES

Always avoid contact between
cables carrying welding current
If there became
ensuring electromagnetic
of old
and compressed gases cylinder and their storage
systems.

Always close the valves on the compressed gas
cylinders when not in use.

The valves on inert gas cylinder should always
be fully opened when in use.

The valves on flammable gases should only be
opened full turn so that quick shut off can be
made in an emergency.

Care should be taken when moving compressed
gas cylinders to avoid damage and accidents
which could result in injury.

Do not attempt to refill compressed gas cylin-
ders, always use the correct pressure reduction
regulators and suitable base fined with the
correct connectors.

For further information consult the safety regu-
lation governing the use of welding gases.
PLACEMENT OF THE MACHINE
When choosing the position of the machine place-
ment, be careful to prevent the machine from con-
ducting impurities and getting them inside (for exam-
ple flying particles from the grinding tool).
ATTENTION! When using the welding machine with
standby power supply, mobile power supply (gene-
rator), it is necessary to use a quality standby supply
with sufficient performance and with quality regula-
tion.
The performance of the machine must comply with
the minimum value of supply on the label of the
machine for maximum load. If you do not adhere to
this rule, there is a danger that the machine will not
weld in a quality way or will stop welding for the
given maximum welding current or that the machine
will be damaged because of great decreases and
increases of the supply voltage.

Installation

The installation site for the system must be carefully
chosen in order to ensure its satisfactory and safe
use. The user is responsible for the installation and
use of the system in accordance with the producer's
instructions contained in this manual. The manufac-
turer is not responsible for damages caused by
improper use and handling. Machines must be
protected from moisture and rain, mechanical
demage, drafts and any possible ventilation of
neighbor machines, excessive overloading and by
rough handling.
Before installing the system the user must take into
consideration the potential electromagnetic prob-
lems in the work area. In particular, we suggest that
you should avoid installing the system close to:
-33 -