Instrument Dialog: Turbine - Sirona C1+ Gebrauchsanweisung

12 Instrument dialogs

12.2 Instrument dialog: Turbine

12.2
Instrument dialog: Turbine
#
38
C
E1
• Actuate the programming key until three successive
acoustic signals sound. Then put the motor back in
its receptacle.
Programming for this motor in function level E1 is com-
pleted now.
After the motor has been removed from the receptacle,
the functions programmed in this function level will
always be available for treatment.
However, they can be changed manually during a treat-
ment.
In this case, the E symbol will appear with a normal
frame.
When the functions are reprogrammed, the previous
functions will be deleted automatically.
On selection of a key and subsequent actuation of the
foot switch, the cursor jumps to the top again.
The turbine instrument dialog appears when a turbine
has been taken out of its receptacle.
When the turbine is put back into the receptacle, the pre-
viously selected dialog appears again.
If several turbines/instruments are removed at the same
time, only the one removed first will be ready for use.
The turbine is started by actuating the foot switch.
The functions of the keys are identical with those in the
electric motor instrument dialog.
However, the following functions are not available: Pre-
selection of speed, reversal of rotation and changeover
to speed controller foot switch.
Programming of functions
For each turbine, different functions can be programmed
for any user (A, B or C, see Neutral dialog 0 or assistant
dialog, page 31 and 32) in the three function levels E1,
E2 and E3:
• Select the desired function level E1, E2 or E3 for the
turbine in use.
• Select the desired functions.
Sirona Dental Systems GmbH
59 06 446 D 3386
D 3386.201.01.08.02