Yamaha YZ250F Fahrer- Und Wartungshandbuch Seite 538

HANDLEBAR
8. Install:
Brake master cylinder 1
G
Brake master cylinder bracket 2
G
Bolt (brake master cylinder bracket) 3
G
NOTE:
Install the bracket so that the arrow mark a
G
faces upward.
First tighten the bolt on the upper side of the
G
brake master cylinder bracket, and then
tighten the bolt on the lower side.
9. Install:
Engine stop switch 1
G
Clutch lever holder 2
G
Bolt (clutch lever holder) 3
G
Hot starter lever holder 4
G
Bolt (hot starter lever holder) 5
G
Clamp 6
G
NOTE:
The engine stop switch, clutch lever holder
G
and clamp should be installed according to
the dimensions shown.
Pass the engine stop switch lead in the mid-
G
dle of the clutch lever holder.
10. Install:
Clutch cable 1
G
Hot starter cable 2
G
NOTE:
Apply the lithium soap base grease on the
clutch cable end and hot starter cable end.
11. Adjust:
Clutch lever free play
G
Refer to "CLUTCH ADJUSTMENT"
section in the CHAPTER 3.
Hot starter lever free play
G
Refer to "HOT STARTER LEVER
ADJUSTMENT" section in the CHAP-
TER 3.
5 - 43
CHAS
9 Nm (0.9 m · kg, 6.5 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)