Using The Rebate Depth Stop; Removing And Installing A Planer Blade; Replacing A Drive Belt; Maintenance And Cleaning - Parkside PEH 30 B2 Bedienungsanleitung

Preparing for use / Maintenance and cleaning
Exert some slight sideways pressure when
□
guiding the planer with the guide fence.

Using the rebate depth stop

●
(see Fig. J)
Attach the rebate depth stop
□
device with the fixing screw
Set the desired rebate depth with the
□
rebate depth stop
Make the required number of passes with
□
the planer until desired rebate depth is
achieved.
Removing and installing a
●
planer blade
DANGER OF INJURY!
Before you carry out any work on the device
always pull the mains plug out of the mains
socket.
CAUTION! The sharp cutting edges of
■
the planer blade
20
hazard! Never touch the cutting edges of
the planer blade
20
The planer blade
20
and it can be fitted either way around.
Replace the planer blade
□
cutting edges are blunt.
Do not resharpen the planer blades
□
Reversing or replacing a planer
blade
20
IMPORTANT INFORMATION:
Do not release the two hex srews
are used to adjust the height of the blade
shaft.
Adjustment is necessary only if you wish
to use a different planer blade type e.g. a
profiled blade.
Always replace both blades at the same time
to avoid out of balance forces.
24 GB / IE / NI
to the
12
.
11
12
.
(see Fig. D + E)
20
present an injury
.
has two cutting edges
when both
20
20
. They
27
NOTE: If you only release one blade first
then you can use the factory-fitted second
blade for orientation when you fit the new
blade.
1. Release the three bolts of the cutting element
using the supplied open spanner
18
Press the removable side guard
□
the slot in the housing.
2. Push the cutting element
from the blade shaft
3. Push the planer blade
from the cutting element
4. Reassembly is carried out in the reverse
order with a reversed or new planer
blade.
5. Planer blades
the service address indicated (see section
about warranty).

Replacing a drive belt

●
(see Figs. F + G)
Before you carry out any work on the device
always pull the mains plug out of the mains
socket.
Release the screws
□
cover .
4
. Remove the worn drive belt
□
First place the new drive belt
□
the small belt wheel
drive belt
23
by rotating it.
24
Put the belt cover
□
and fasten it into place with the screws
.
5

Maintenance and cleaning

●
Before you carry out any work on the device
always pull the mains plug out of the mains
socket.
21
sideways out
18
.
17
sideways out
20
.
18
can be obtained from
20
DANGER OF INJURY!
and remove the belt
5
23 .
on to
23
and then pull the
25
on to the large belt wheel
back into position
4
DANGER OF INJURY!
.
26
into