External extraction:
When using dust extraction systems, e .g . a work-
shop extractor, it may be necessary to use the
adapter for external extraction
cleaner must be suitable for the material being
processed .
Connecting:
♦
Push the adapter for external extraction
firmly into the chip ejector
♦
Push the hose of a suitable dust extraction ap-
pliance (e .g . a workshop vacuum cleaner) onto
the chip ejector
extraction
, if required) .
Removal:
♦
Pull the hose of the vacuum cleaner off the chip
ejector
or the adapter .
♦
Pull the adapter for external extraction
Parking shoe (see fig . B)
The parking shoe
allows you to put down the
appliance without risking damage to the work-
piece . While working, the parking shoe
flipped up and rear part of the plane sole
exposed .
Planing
CAUTION! RISK OF KICKBACK!
Always switch the appliance on before applying
it to the workpiece .
♦
Set desired cut depth .
♦
Switch the appliance on .
♦
Place the appliance with the front part of the
plane sole
on the workpiece .
♦
Move the appliance with straight, even motions
over the workpiece .
♦
Push forward slowly and do not exert excessive
pressure on the plane sole
reduces the surface finish and can lead to a jam
in the chip ejector .
PEH 30 C3
. The vacuum
.
(or the adapter for external
is
. Excessive speed
Chamfering edges
The V grooves
easy chamfering of workpiece edges .
♦
Use the V groove that corresponds to the chamfer
width required .
♦
Place the planer with the V groove
workpiece edge and guide it forwards .
Using the rip fence
♦
The fit the rip fence, guide the connecting screw
through the connecting piece
8b
fence
.
♦
Screw the lock nut
screw
.
8b
♦
Fit the rip fence
fastening screw
♦
Undo the lock nut
off .
♦
Retighten the lock nut
♦
Ensure that the plane is applied with lateral
pressure .
Using the fold depth stop
♦
Fit the fold depth stop
is
using the fastening screw
♦
Set the desired fold depth using the fold depth
stop
.
♦
Repeat the planing process several times until
the required fold depth is achieved .
Removing/replacing the planing
blade
(see figs . C + D)
WARNING! RISK OF INJURY
►
Always remove the plug from the power
socket before working on the appliance .
CAUTION!
There is a risk of injury due to the cutting edges
of the planing blade
Never touch the planing blade
edges .
The planing blade
can be turned .
in the front plane sole
and the rip
8a
onto the connecting
onto the appliance using the
.
and set the desired width .
.
onto the appliance
.
!
on its cutting
has two cutting edges and
GB │ IE │ NI
allow
onto the
│
7
■