General Power Tool Safety Warnings; Work Area Safety; Electrical Safety - Parkside PEH 30 B2 Bedienungsanleitung

Wear ear protection!
Vibration emission value:
Main handle: ah=1.939 m/s
auxiliary handle: ah=2.719 m/s
Uncertainty K = 1.5 m / s
The vibration level specified
in these instructions was measured in
accordance with an EN 60745 standardised
measurement process and can be used
to compare equipment. The vibration
emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level will change according
to the application of the electrical tool an in
some cases may exceed the value specified
in these instructions. Regularly using the
electric tool in such a way may make it easy
to underestimate the vibration.
Note: If you wish to make an accurate
assessment of the vibration loads
experienced during a particular period of
working, you should also take into account
the intervening periods of time when the
device is switched off or is running but is
not actually in use. This can result in a much
lower vibration load over the whole of the
period of working.
General power tool
●
safety warnings
Wear ear protection
warnings and all instructions.
Failure to follow the warnings and
instructions may result in electric shock, fire
and / or serious injury.
Save all warnings and instructions
Introduction / General power tool safety warnings
Read all safety
for future reference!
The term "power tool" in the warnings refers
to your mains-operated (corded) power tool
or battery-operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well
lit. Cluttered or dark areas invite
accidents.
b) Do not operate power tools in
explosive atmospheres, such as in
the presence of flammable liquids,
gases or dust. Power tools create
sparks which may ignite the dust or fumes.
c) Keep children and bystanders
away while operating a power
tool. Distractions can cause you to lose
control.

2. Electrical safety

a) Power tool plugs must match the
outlet. Never modify the plug in
any way. Do not use any adapter
plugs with earthed (grounded)
power tools. Unmodified plugs and
matching outlets will reduce risk of electric
shock.
b) Avoid body contact with earthed
or grounded surfaces, such as
pipes, radiators, ranges and
refrigerators. There is an increased risk
of electric shock if your body is earthed or
grounded.
c) Do not expose power tools to rain
or wet conditions. Water entering a
power tool will increase the risk of electric
shock.
d) Do not abuse the cord. Never use
the cord for carrying, pulling or
unplugging the power tool. Keep
cord away from heat, oil, sharp
edges or moving parts. Damaged
GB / IE / NI 19