General power tool safety warnings /Preparing for use
the mains socket.
When taking a break from your
■
work, before carrying out any
tasks on the device itself (e.g.
changing the plane blade) or when
you are not using the device,
always pull the mains plug out of
the mains socket.
Always work with the mains lead
■
leading away from the rear of the
device.
Use sharp planer blades only.
■
Do not soak the materials or the
■
surface you are about to work on
with liquids containing solvents.
Avoid contact with rotating parts.
■
Never use the device for a purpose
■
for which it was not intended
or with non-original parts /
accessories.
Hold the device securely when
■
working. Ensure that you are standing
in a stable, well-balanced position.
Always keep the device clean, dry
■
and free from oil or grease.
Safety instructions for planers
●
Wait for the cutter spindle to stop
■
completely before setting down the power
tool. An exposed rotating cutter spindle
can catch on the surface, resulting in loss
of control and serious injuries.
Only hold the power tool by the insulated
■
handle areas as the cutter spindle may
touch the tool's mains cable. Contact with
a live wire could cause metal parts of the
device to become live and lead to electric
shock.
Fix and secure the work piece to a stable
■
surface using clamps or other means.
When only securing the work piece by
hand or against your body it will remain
22 GB / IE / NI
unstable, which could lead to loss of
control.
Original accessories /
●
attachments
Use only the accessories and
■
attachments detailed in the
operating instructions. The use of
attachments or accessories other than
those recommended here could lead to
you suffering an injury.
Preparing for use
●
Switching On / Off
●
Switching on:
First press the safety lock-out
□
Then press and keep pressed the ON /
□
OFF switch
.
2
Switching off:
Release the ON / OFF switch
□
Note: For safety reasons the ON / OFF
switch
cannot be locked in the ON
2
position.
Setting the cutting depth
●
The rotary control
13
the cutting depth in steps from 0–3.0 mm
according to the cutting depth scale
Vacuum extraction of dust /
●
debris (see Fig. A)
Wear a dust mask!
DANGER OF INJURY!
Before you carry out any work on the device
always pull the mains plug out of the mains
.
1
2
.
can be used to set
.
14