Parking Shoe (See Fig. B); Planing; Chamfering Edges; Using The Rip Fence - Parkside PEH 30 C3 Originalbetriebsanleitung

External extraction:
When using dust extraction systems, e.g. a work-
shop extractor, it may be necessary to use the
adapter for external extraction
cleaner must be suitable for the material being
processed.
Connecting:
♦ Push the adapter for external extraction
firmly into the chip ejector
♦ Push the hose of a suitable dust extraction ap-
pliance (e.g. a workshop vacuum cleaner) onto
the chip ejector
extraction , if required).
Removal:
♦ Pull the hose of the vacuum cleaner off the chip
ejector or the adapter.
♦ Pull the adapter for external extraction
Parking shoe (see fig. B)
The parking shoe allows you to put down the
appliance without risking damage to the work-
piece. While working, the parking shoe
flipped up and rear part of the plane sole
exposed.

Planing

CAUTION! RISK OF KICKBACK!
Always switch the appliance on before applying
it to the workpiece.
♦ Set desired cut depth.
♦ Switch the appliance on.
♦ Place the appliance with the front part of the
plane sole on the workpiece.
♦ Move the appliance with straight, even motions
over the workpiece.
♦ Push forward slowly and do not exert excessive
pressure on the plane sole
reduces the surface finish and can lead to a jam
in the chip ejector.
PEH 30 C3
. The vacuum
.
(or the adapter for external
is
. Excessive speed

Chamfering edges

The V grooves
easy chamfering of workpiece edges.
♦ Use the V groove that corresponds to the chamfer
width required.
♦ Place the planer with the V groove
workpiece edge and guide it forwards.

Using the rip fence

♦ The fit the rip fence, guide the connecting screw
through the connecting piece
8b
fence .
♦ Screw the lock nut
screw .
8b
♦ Fit the rip fence
fastening screw
♦ Undo the lock nut
off.
♦ Retighten the lock nut
♦ Ensure that the plane is applied with lateral
pressure.

Using the fold depth stop

♦ Fit the fold depth stop
is
using the fastening screw
♦ Set the desired fold depth using the fold depth
stop .
♦ Repeat the planing process several times until
the required fold depth is achieved.
Removing/replacing the planing
blade (see figs. C + D)
WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance.
CAUTION!
There is a risk of injury due to the cutting edges
of the planing blade
Never touch the planing blade
edges.
The planing blade
can be turned.
in the front plane sole
and the rip
8a
onto the connecting
onto the appliance using the
.
and set the desired width.
.
onto the appliance
.
!
on its cutting
has two cutting edges and
GB │ IE
allow
onto the
│
19 ■