Disposal; Packaging - Abicor Binzel CR1000 Betriebsanleitung

12 Disposal

12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines must be observed. Observe the
regulations on the disposal of electronic scrap and dispose of it at your local waste disposal site (e.g. recycling centre).
To correctly dispose of the product, it first must be disassembled. Please take note of the following information:
 11 Disassembly on page EN-17
BTC coolants:
The coolant must not be disposed of with normal household waste. Do not allow it to enter the sewage system. Please take
note of the following information in the safety data sheet:
 Section 13 Disposal instructions
• 14 06 03*: other solvents and solvent mixtures
• 15 01 10*: Packaging that contains residues of dangerous materials or has been soiled by dangerous materials
• 15 01 02: Plastic packaging
Contaminated packaging:
Recommendation: disposal in accordance with official regulations.
Recommended cleaning agents: water, if necessary with added cleansing agents.
12.1 Materials
This product is mainly made of metallic materials which can be melted in steel and iron works and are thus almost infinitely
recyclable. The plastic materials used are labeled in preparation for their sorting and separation for later recycling.
12.2 Consumables
Oil, greases and cleaning agents may not contaminate the ground or enter the sewage system. These materials must be
stored, transported and disposed of in suitable containers. Observe the relevant local regulations and disposal instructions
of the safety data sheets specified by the manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.)
must also be disposed of in accordance with the information provided by the consumables' manufacturer.

12.3 Packaging

ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
EN - 18
CR1000/CR1250
BAL.0351.0 • 2018-08-15