Disassembly; Disposal; Packaging - Abicor Binzel BRS-LC Betriebsanleitung

BRS-LC

11 Disassembly

DANGER
Risk of injury due to unexpected start
Improper operation can lead to serious injuries that could result in death.
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Observe the information in chapter:
 8 Decommissioning on page EN-24
1 Unscrew the screws and remove the cleaning unit.

12 Disposal

To correctly dispose of the product, it must first be disassembled. When disposing of the system, local regulations, laws,
provisions, standards and guidelines must be observed.
 11 Disassembly on page EN-27
12.1 Materials
This product is mainly made of metallic materials that can be melted in steel and iron works and are thus almost infinitely
recyclable. The plastic materials used are labeled in preparation for their sorting and separation for later recycling.
12.2 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These substances must be
stored, transported and disposed of in suitable containers. Observe the relevant local regulations and disposal instructions
in the safety data sheets specified by the manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.)
must also be disposed of in accordance with the information provided by the consumables' manufacturer.

12.3 Packaging

ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
BAL.0030.0 • 2021-01-19
11 Disassembly
EN - 27