Maintenance And Cleaning; Replacing Wear Parts, Fig; Cleaning The Welding Torch; Disposal - Abicor Binzel xFUME TIG Originalbetriebsanleitung

7 Maintenance and cleaning

7 Maintenance and cleaning
WARNING
Risk of injury from hot coolant
If the coolant hose is disconnected during or straight after operation, coolant can spray out and burn or irritate skin and mucous membranes.
► Allow the welding torch and coolant to cool down.
► Check and wear your personal protective equipment.
WARNING
Risk of burns from hot surface
Welding torches become very hot during welding. They could cause major burns.
► Allow welding torches to cool down after welding.
► Wear the correct protective gloves.
CAUTION
Risk of injury due to unexpected start
If the device is energised during maintenance, cleaning or disassembly work, parts can unexpectedly start up and cause injuries.
► Switch off the device.
► Close off all supply lines.
► Disconnect the electrical power supply.
7.1

Replacing wear parts, Fig. 6

NOTICE
Material damage through the use of unsuitable wear parts and mounting tools
The use of wear parts from other manufacturers and the improper installation of wear parts can cause material damage to the welding torch and impair work
results.
► Only use original ABICOR BINZEL wear parts.
► Ensure that the welding-torch-specific wear parts are correctly assigned.
► Use the ABICOR BINZEL switch key wrench to attach and remove wear parts.
The torch neck can be fitted with various wear parts depending on the
welding task.
7.2

Cleaning the welding torch

The parts listed below are subject to wear and soiling. As a result, they must
undergo regular maintenance and cleaning:
— Torch body
— Gas nozzle
8

Disposal

Tab. 5
Critical raw materials in welding torches equipped for welding
Tungsten (tungsten electrode)
Equipment marked with this symbol is covered by European Directive 2012/19/EU on waste electrical and electronic equipment (WEEE).
► Do not dispose of electrical devices with household waste.
► Disassemble electrical devices before they are disposed of.
► Collect components of electrical separately and recycle in an environmentally responsible manner.
► Observe local regulations, laws, provisions, standards and guidelines.
► Please consult your local authority for information about collection and return of electrical devices.
9

Warranty

This product is an original ABICOR BINZEL product.
Alexander BINZEL Schweisstechnik GmbH & Co. KG guarantees correct
manufacture and assumes a plant production and function warranty for this
product upon delivery in line with current state-of-the-art technology and the
regulations in force. If ABICOR BINZEL is responsible for a defect that occurs,
ABICOR BINZEL is obliged to remedy the defect or deliver a replacement at
its own cost and its own discretion. The warranty covers manufacturing faults,
but not damage resulting from natural wear and tear, overloading or
improper use.
The warranty period is defined in the General Terms and Conditions.
EN - 36
> 1 g
► Order data and part numbers for the equipment parts and wear parts
can be found in the current order documents.
► Mount wear parts as shown in the figure.
— Tungsten electrode
— Back cap
— Gas diffuser
Exceptions in the case of specific products are regulated separately.
The warranty will also be rendered invalid if spare and wear parts are used
that are not original ABICOR BINZEL parts and if the product has been
repaired improperly by the user or a third party.
Wear parts are excluded in general from the warranty. In addition,
ABICOR BINZEL is not liable for damage caused by using our products.
Questions about warranty and service can be addressed to the manufacturer
or our distributors. For more information, visit www.binzel-abicor.com.
®
xFUME TIG