Bus Termination; Bus Address; Shield Cover - TR-Electronic C H-80 Serie Benutzerhandbuch

4.3.2 Bus termination

If the measuring system is the last slave
in the PROFIBUS segment, the bus is to
be terminated with the termination
switch
subsequent PROFIBUS is decoupled.

4.3.3 Bus address

Valid PROFIBUS addresses: 3 - 99
0
10 : Setting the 1st position
1
10 : Setting the 10th position
The device does not start up with an
invalid station address.

4.3.4 Shield cover

The shielding is to be connected with large surface on the mating connector.
Printed in the Federal Republic of Germany
11/07/2018
= ON. In this state,
TR - ECE - BA - DGB - 0076 - 08
the
 TR-Electronic GmbH 2010, All Rights Reserved
Page 73 of 111