Station Status 1; Station Status 2; Station Status 3 - TR-Electronic C H-80 Serie Benutzerhandbuch

7.2.1.1 Station status 1

bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0

7.2.1.2 Station status 2

bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0

7.2.1.3 Station status 3

bit 7
bit 6-0 Reserved
Printed in the Federal Republic of Germany
11/07/2018
Master_Lock
Parameter_Fault
Invalid_Slave_Response
Not_Supported
Ext_Diag
Slave_Cfg_Chk_Fault
Station_Not_Ready
Station_Non_Existent
Deactivated
Reserved
Sync_Mode
Freeze_Mode
WD_On
Slave_Status
Stat_Diag
Prm_Req
Ext_Diag_Overflow
TR - ECE - BA - DGB - 0076 - 08
Slave has been parameterized
from another master (bit is set by
the master)
The parameter telegram last sent
has been rejected by the slave
Is set by the master, if the slave
does not respond
Slave does not support the
requested functions.
Bit = 1 means an extended
diagnosis report from the slave is
waiting
The configuration identifier(s)
sent from the master has (have)
been rejected by the slave
Slave is not ready to exchange
cyclical data
The slave has been projected,
but is not available on the bus
Slave was removed from the poll
list from the master
Is set by the slave after receipt of
the SYNC command
Is set by the slave after receipt of
the FREEZE command
The response monitoring of the
slave is activated
Always set for slaves
Static diagnosis
The slave sets this bit if it has to
be re-parameterized and
reconfigured.
Overrun for extended diagnosis
 TR-Electronic GmbH 2010, All Rights Reserved
Page 105 of 111