Bus Termination; Bus Address; Shield Cover - TR-Electronic C H-80 Serie Benutzerhandbuch

4.2.2 Bus termination

If the measuring system is the last slave
in the PROFIBUS segment, the bus is to
be terminated with the termination
switch
subsequent PROFIBUS is decoupled.

4.2.3 Bus address

Valid PROFIBUS addresses: 3 - 99
0
10 : Setting the 1st position
1
10 : Setting the 10th position
The device does not start up with an
invalid station address.

4.2.4 Shield cover

The shield cover is connected with a special EMC cable gland, whereby the cable
shielding is fitted on the inside.
Prepare the PROFIBUS cable (e.g. 2-wire)
Printed in the Federal Republic of Germany
11/07/2018
= ON. In this state,
The dimension "X" depends on the type and size of the cable gland.
TR - ECE - BA - DGB - 0076 - 08
the
1
10
approx. 80 mm
X mm
ON
OFF
0
10
5mm
 TR-Electronic GmbH 2010, All Rights Reserved
Page 69 of 111