Display Screen Messages; Error Messages - Wisniowski AWso2018 Technische Dokumentation Und Beschreibung/Montage Und Bedienungsanleitung

15.1. DISPLAY SCREEN MESSAGES
The controller display shows messages informing about the status of the gate, access restrictions, and errors.
Message
cL/CL
cL/CL
cL/CL
cH/CH
oP/OP
oP/OP
oP/OP
oH/OH
Hr
oS
E1
E2
E3
E4
E5
E6
E7
E8
*The case of the first letter informs about the calibration status of the gate:
• lower case – the gate is not calibrated
• upper case – the gate is calibrated
Technical documentation and description + IIiO/AWso2018/06/2018/ID-97354
Assembly and Operating Instructions – Drive unit for gates AWso2018
Flashing
Gate status messages
gate closed
cL/CL closing in progress
L closing – slowed-down
stopped when closing
gate open
oP/OP opening in progress
P opening – slowed-down
stopped when opening
Control restriction messages
no reaction to the remote control input – Hold to Run function
no reaction to the remote control input – Housing estate function
Error messages
no reaction because of a motor short-circuit
E1 stopped because of a motor short-circuit
no reaction because of an interruption of the optical barrier
E2 stopped because of an interruption of the optical barrier
no reaction because of the active STOP input
E3 stopped because of the active STOP input
no reaction because of the active 8k2 input
E4 stopped because of the active 8k2 input
E5 stopped because of overload triggering
no reaction because of the actuating relay failure
no reaction because of the safety edge detection system failure
no reaction because of the motor current measurement system failure
Meaning
EN
7