Operation - Ryobi RLM1956MEB Originalanleitung

8. Power lever
9. Rope guide knob
10. Air fi lter
11. Panel
ASSEMBLY
UNPACKING
This product requires assembly.
■ Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing
list are included.
■ Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
■ If any parts are damaged or missing, please call your
Ryobi service centre for assistance.
WARNING
Do not use this product if any parts on the packing list
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
WARNING
If any parts are damaged or missing do not operate this
product until the parts are replaced. Using a product
with damaged or missing parts could result in serious
personal injury.
WARNING
Do not attempt to modify the product or create
accessories not recommended for use with the product.
Any such alteration or modifi cation is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING
Never attach or adjust any accessory while the mower
is running. Failure to stop the engine may cause
serious personal injury.
WARNING
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark
plug wire from the spark plug when assembling parts.
WARNING
Never operate the mower without the proper safety
devices in place and working. Never operate the mower
with damaged safety devices. Operation of this product
with damaged or missing parts could result in serious
personal injury.
INSTALLATION OF THE PANEL
See fi gure 1a.
■ Use a wrench and socket set (not provided) with the
bolts and nuts to secure the panel on the handle.
INSTALLATION OF THE HANDLE
See fi gure 2.
1. Place handles in correct operating position and tighten
handle knobs to secure.
2. Loosen rope guide knob, place starter rope in guide on
handle, then retighten knob to secure.
3. Install grass catcher or mulching plug.
SETTING BLADE HEIGHT
See fi gure 3.
When shipped, the wheels on the mower are set to a low-
cutting position. Before using the mower for the fi rst time,
adjust the cutting position to the height best suited for your
lawn. The average lawn should be between 3 and 6 cm,
depending on the season.
■ To raise the blade height, grasp the height adjustment
lever and move it toward the back of the mower.
■ To lower the blade height, grasp the height adjustment
lever and move it toward the front of the mower.

OPERATION

MOWING TIPS
■ Make sure the lawn is clear of stones, sticks, wires, and
other objects that could damage the lawn mower blades
or engine. Such objects could be accidentally thrown by
the mower in any direction and cause serious personal
injury to the operator and others.
■ For best performance, always cut off one-third or less of
the total height of the grass.
■ When cutting long grass, reduce walking speed to allow
for more effective cutting and a proper discharge of the
clippings.
■ Do not cut wet grass, it will stick to the underside of the
deck and prevent proper bagging or mulching of grass
clippings.
■ New or thick grass may require a higher cutting height.
■ Clean the underside of the mower deck after each use
to remove grass clippings, leaves, dirt, and any other
accumulated debris. Refer to "Cleaning the underside
of the mower deck" section later in this manual.
EN
English
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
3