Additional Safety Instructions - Parkside PWSA 12-LI A1 Originalbetriebsanleitung

GB IE NI
working area should
wear personal protective
equipment. Broken bits from
the piece being worked or
broken attachment tools can fly
away and cause injuries even
beyond the direct working
area.
• Keep the cord away
from the rotating attach-
ment tool. If you lose con-
trol of the device, the power
cord can become separated
or caught and your hand or
arm may be pulled into the
rotating attachment tool.
• Never put the electric
tool down before the at-
tachment tool has come
to a full stop. The rotating
attachment tool can come into
contact with the surface upon
which it is set, whereby you
could lose control of the elec-
tric tool.
• Never allow the elec-
tric tool to run while
you are carrying it. Your
clothing may accidentally
come into contact with the
rotating attachment tool and
get caught and the attach-
ment tool could drill into your
body.
• Clean the ventilation
slots of your electric tool
routinely. The motor air
pulls dust into the housing
and, should too much metallic
dust collect, could cause elec-
trical hazards.
• Never use the electric
tool near flammable
material. Sparks could igni-
1 4
CY
te this material.
• Do not use attachment
tools which require li-
quid coolant. Using water
or another liquid coolant
could lead to electrical shock.
Additional safety
instructions
• Only use grinding discs whe-
re the indicated rotational
speed is at least as high as
what has been specified on
the name plate of the device.
• Carry out a visual inspection
of the grinding disc before use.
Do not use any damaged or
deformed grinding discs. Re-
place any damaged or worn
grinding discs.
• Make sure that the sparks
produced by grinding do not
present a danger, e.g. reach
people or ignite flammable
substances.
• Always wear safety goggles,
safety gloves, respiratory pro-
tection and ear protection
when grinding, brushing and
cutting.
• Never keep the fingers bet-
ween the grinding disc and
spark protection or in close
proximity to the protective
hoods. There is a risk of crus-
hing.
• The rotating parts of the de-
vice cannot be covered due
to functional reasons. There-
fore, proceed cautiously and
hold the workpiece firmly in
order to avoid slipping which