Checking The Battery Charge Level; Assembly; Set Protective Hood; Installing/Changing The Cutting/Grinding Disc - Parkside PWSA 12-LI A1 Originalbetriebsanleitung

Checking the battery charge
level
The battery's (
cated by the charge state indicator (
The LEDs indicate the battery's charge
level, when the device is in operation.
Press and hold the power button (
red-yellow-green => Battery fully charged
red and yellow
=> Battery half charged
red
=> Battery needs

Assembly

Caution! Risk of injury!
- Ensure that you have sufficient
space in which to work, and that
you do not endanger other people.

Set protective hood

Adjust the protective hood such that any
sparks or detached parts cannot hit either
the user or any bystanders.
The protective hood must also be positi-
oned such that the sparks cannot ignite
combustible parts, including those in the
surroundings.
The device must only be
operated with the protective
hood mounted.
1. Remove the battery (9). Press the
battery release buttons (8) and
pull the battery (9) out of the
tool.
9) charge level is indi-
to be charged
2.
6).
Installing/changing the
cutting/grinding disc
Before initial operation,
5).
check the tightness of the
clamping screw (3).
1. Press the spindle retaining tab
2. Loosen the clamping screw (3)
3. Position the desired cutting/
4. Reposition the clamping flange
5. Press the spindle retaining tab (4)
If the direction of rotation is marked
on your cutting/grinding disc, make
sure that it matches the direction of
rotation mark on the tool.
GB IE
Turn the protective hood (1) into
the working position. The closed
side of the protective hood must
always face the operator.
(4) and keep it pressed.
with the Allen key (11). You can
now release the spindle retaining
tab (4).
grinding disc (2) on the moun-
ting flange ( 16). The label on
the cutting/grinding disc should
always face the tool.
(17). The side of the clamping
flange ( 17). The side of the
clamping flange (
cess generally points to the attach-
ment tool and thus to the cutting/
grinding disc (2).
and tighten the clamping screw (3)
using the Allen key (11). You can
now release the spindle retaining
tab (4).
NI CY
17) with re-
1 9