Safety Instructions For All Applications - Parkside PWSA 12-LI A1 Originalbetriebsanleitung

GB IE NI
charger rating plate. Risk
of electric shock.
• Keep the charger clean
and away from wet
and rain. Do not use
the charger outdoors.
Dirt and the entry of water
increase the risk of electric
shock.
• Operate the charger
only with the appropri-
ate original batteries.
Charging other batteries may
result in injuries and risk of
fire.
• Avoid mechanical dam-
age to the charger. This
can result in internal short
circuits.
• Do not operate the
charger on a combusti-
ble surface (e.g. paper,
textiles). Risk of fire due to
heating during charging.
• If the connection ca-
ble of this appliance is
damaged, it must be re-
placed by the manufac-
turer or their customer
service or by a similarly
qualified person in or-
der to avoid hazards.
• The battery of the appliance
is not fully charged at the
time of delivery. It therefore
needs to be fully recharged
before you use it for the first
time. Slot the battery into the
base and plug the battery
charger into a mains outlet..
• Disconnect the mains plug
when the battery is fully
charged and disconnect the
battery from the charger.
1 2
CY
Do not allow your battery to
charge continuously. This can
damage the battery cells. Do
not briefly charge the bat-
tery several time in a row.
Recharge the battery when
you notice that the appliance
is becoming slower.
• Do not use the charger to
charge non-rechargeable bat-
teries.
Safety instructions for
all applications
Common safety
instructions for grinding
and cutting:
• This electric tool is to be
used as a grinder and
cutting grinder. Follow
all safety instructions, di-
rectives, illustrations and
facts which you receive
with the device. If you do
not follow these instructions,
an electrical shock, fire and/
or serious injury may occur.
• This electric tool is not
suitable for sanding,
wire brushing and po-
lishing. Using the electric
tool in ways for which it is not
intended may cause hazards
and injuries.
• Do not use any ac-
cessories that are not
specifically intended
and recommended for
this electric tool by the
manufacturer. Simply be-
cause an accessory can be