Special Safety Directions For Battery-Operated Tools; Correct Handling Of The Battery Charger - Parkside PWSA 12-LI A1 Originalbetriebsanleitung

parts. This will ensure that
the safety of the power tool is
maintained.
SPECIAL SAFETY
DIRECTIONS FOR
BATTERY-OPERATED
TOOLS
• Ensure that the device
is switched off before
inserting the battery.
Inserting a battery into a
power tool that is switched
on may result in accidents.
• Recharge the batteries
indoors only because
the battery charger is
designed for indoor use
only.
• To reduce the electric
shock hazard, unplug
the battery charger
from the mains before
cleaning the charger.
• Do not subject the bat-
tery to strong sunlight
over long periods and
do not leave it on a
heater. Heat damages the
battery and there is a risk of
explosion.
• Allow a hot battery to
cool before charging.
• Do not open up the bat-
tery and avoid mechani-
cal damage to the bat-
tery. Risk of short circuit and
fumes may be emitted that
irritate the respiratory tract. En-
sure fresh air and seek medi-
cal assistance in the event of
discomfort.
GB
• Do not use non-re-
chargeable batteries!
Correct handling of the
battery charger
• This appliance can be used
by children aged from 8
years and above and per-
sons with reduced physical,
sensory or mental capabilities
or lack of experience and
knowledge if they have been
given supervision or instruc-
tion concerning use of the
appliance in a safe way
and understand the hazards
involved. Children shall not
play with the appliance.
Cleaning and user mainte-
nance shall not be made by
children without supervision.
• To charge the battery,
use only the charger
supplied. Risk of fire and
explosion. This ensures that
the safety of the device is
maintained.
• Before each use, check
the charger, cable and
plug and have them re-
paired by qualified pro-
fessionals and only with
original parts. Do not use
a defective charger and do
not open it up yourself. This
ensures that the safety of the
device is maintained.
• Connect the charger
only to a socket with an
earth. Ensure that the
mains voltage matches
the specifications on the
IE NI CY
1 1