Special Safety Instructions For Grinding And Cutting - Parkside PWSA 12-LI A1 Originalbetriebsanleitung

GB IE NI
at the blocked spot. Here, the
grinding discs can also break. A
kickback is caused by wrongly
or incorrectly operating the elec-
tric tool. It can be avoided by
suitable cautionary measures,
such as described below.
a) Hold the electric tool very firm-
ly and bring your body and
your arm into a position in
which you can resist the kick-
back force. Always use the
supplemental handle if availa-
ble to give you the best control
over kickback force or reac-
tion time during acceleration.
The operator can master the
kickback and reaction force
through suitable precautions.
b) Never bring your hands near
a rotating attachment tool.
The attachment tool can run
over your hand in the kick-
back.
c) Keep your body away from
the area in which the electric
tool would move during a
kickback. The kickback drives
the electric tool in the counter-
direction to the rotation of the
grinding disc at the blocked
spot.
d) Work particularly cautiously
in corner areas or where the-
re are sharp corners etc. Pre-
vent the attachment tools from
recoiling from the workpiece
and jamming. The rotating
attachment tool tends to jam
when near corners, sharp
edges or when it recoils from
such. This causes a loss of
control or kickback.
1 6
CY
e) Do not use chain or toothed
saw blades. Such attachment
tools frequently cause a kick-
back or loss of control over
the electric tool.
Special safety instructions
for grinding and cutting
a) Use only grinders which have
been approved for your elec-
tric tool and the protective
hood intended for these grin-
ders. Grinders which are not
intended for the electric tool
may not be sufficiently shiel-
ded and are unsafe.
b) Depressed Center grinding
wheels must be pre-assem-
bled so that their surface not
above the level of the edge
of the guard stands out. An
improperly mounted grinding
wheel, which extends beyond
the level of the edge of the
guard, not sufficiently shiel-
ded.
c) The protective hood must
be securely attached to the
electric tool and adjusted
so that the greatest level of
safety is reached, i.e., the
smallest possible amount of
the grinder is exposed to the
operator. The protective hood
should protect the operator
from broken bits and acciden-
tal contact with the grinder.
d) Grinders may only be used
for the recommended attach-
ment options. For example:
Never grind with the side sur-
face of a cutting disc. Cutting