After Each Use - Briggs & Stratton 020622-00 Bedienungsanleitung

Applying Detergent
WARNING! Chemicals could cause burns resulting
in death or serious injury. DO NOT use caustic liquid
with pressure washer. Use ONLY pressure washer
safe detergents /soaps. Follow manufacturers instructions.
To apply detergent, follow these steps:
1. Remove cap from detergent tank (C) and fill with
detergent solution. Replace cap.
2. Install white spray tip.
NOTICE Detergent cannot be applied with turbo or
yellow degree spray tip.
3. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
4. Allow detergent to "soak in" per detergent manufacturer's
instructions before washing and rinsing.
Pressure Washer Rinsing
1. Remove white spray tip from wand and install yellow spray tip.
WARNING! Kickback from spray gun could cause
you to fall resulting in death or serious injury.
Operate pressure washer from a stable surface. Be
extremely careful if you must use the pressure washer from
a ladder, scaffolding, or any other similar location. Firmly
grasp spray gun with both hands when using high pressure
spray to avoid injury when spray gun kicks back.
2. Apply a high pressure spray to a small area and check
surface for damage. If no damage is found, continue rinsing.
3. Start at top of area to be rinsed, working down with
same overlapping strokes as you used for cleaning.
Stopping Pressure Washer
1. Release spray gun trigger.
2. Press master ON/OFF switch (D) to OFF (0) position.
NOTICE Releasing the trigger will shut off the motor but
does not shut off electrical power to the unit.
3. Turn off water supply.
4. ALWAYS point spray gun in a safe direction, press
trigger lock button, and squeeze trigger to relieve built
up pressure in the unit.
WARNING! The high pressure stream of water that
this equipment produces could cut through skin and its
underlying tissues, resulting in serious injury and
possible amputation. Keep high pressure hose connected to
pump and spray gun while system is pressurized. DO NOT allow
CHILDREN to play with or operate pressure washer. ALWAYS
point spray gun in safe direction, squeeze spray gun trigger to
release high pressure, every time you turn off pressure washer.
5. Disconnect PRCD plug (G) from outlet and coil power
cord on bottom hook of accessory tray.
6. Wrap high pressure hose on top hook of accessory tray.
7. Store spray gun, wand and spray tips on accessory tray.
6
Figure
4
Figure
4

After Each Use

Water should not remain in the unit for long periods of time.
Sediments or minerals can deposit on pump parts and "freeze"
pump action. Follow these procedures after every use:
1. Run pressure washer with white spray tip until tank is empty.
2. Add 0.5 liter (0.5 quart) of water to detergent tank, and
run with white spray tip. Flush one to two minutes.
3. Press master ON/OFF switch to OFF (0) position.
Remove power cord plug from electrical outlet.
4. Turn off water supply. Point gun in a safe direction,
press trigger lock button, and squeeze trigger to
relieve trapped pressure.
5. Disconnect garden hose from water inlet. Disconnect
high pressure hose from gun and high pressure outlet.
6. Drain water from hose and spray gun, wipe off all
exterior surfaces.
7. Drain water from pump by tipping unit onto its right
side (water inlet facing down) for two minutes. Flip
unit over and let rest on high pressure outlet for an
additional two minutes.
8. Wrap high pressure hose on top hook of accessory tray.
9. Coil power cord around bottom hook of accessory tray.
Store spray gun and plastic wand on accessory tray.
Store spray tips in holder.
10. Store unit in a clean, dry area.
11. If storing for more than 30 days, see Storage.
BRIGGSandSTRATTON.COM