Stomps Section; Stomp Types; Stack Section; Amplifier Module - Kemper PROFILER Bedienungsanleitung

26 KEMPER PROFILER

Stomps Section

This is a mono Section. It includes all the built-in stomp box simulations that you can place before (pre-) your
virtual amplifier. An idle Stomp Module can be activated by pressing and holding the corresponding STOMP A-D
button. Use the TYPE knob to browse through all available stomp algorithms. Selecting an option will load the
stomp, and close the list browser.

Stomp Types

There are several types of stomp boxes available in the Stomps Section, such as various wah effects, including
bandpass and comb filters. There are also several distortion stomps available, modeled after famous vintage
pedals. On top of all this, modulation stomps such as Vintage Chorus, Hyper Chorus, Air Chorus, Flanger, Phaser,
Vibrato, Tremolo, and Rotary Speaker are included. Most stomp parameters are self-explanatory, and a detailed
overview of all available stomp parameters can be found in the Reference Manual.

Stack Section

This is your "amplifier stack", consisting of your Amplifier Profile, EQ, and, Cabinet Profile. Hold the STACK but-
ton for a moment to enter the edit mode of the Stack Section. You can rename the Stack using the "Rename" soft
button. Turn the BROWSE knob to browse through your Presets, like in any other Section. Specifically, whilst in
the Stack Section you can choose "From Rigs" to browse stacks included in other Rigs according to your «View»
and «Sorted by» selections. This Selective Browse functionality is available for Stack Section, Amp Module, and
Cabinet Module.

Amplifier Module

Hold the AMPLIFIER button to open the Amplifier Module. Here you can change settings of the Amplifier Profile
as well as select and load other Amplifier Profiles to create new stack combinations. You can find more informa-
tion regarding the amp parameters in the Reference Manual.