Input Source Select; Input Led - Kemper PROFILER Bedienungsanleitung

Input Source Select

You have the choice of four different physical inputs: Front INPUT, ALTERNATIVE INPUT, RETURN INPUT and S/
PDIF INPUT.
FRONT INPUT
ALTERNATIVE
INPUT
RETURN INPUT
REAMP
S/PDIF INPUT
REAMP
Reamp Sens
♦
A very detailed description can be found in the "Reamping" chapter in the Reference Manual.
(12)

Input LED

The LED reflects the level of the input signal.
The standard instrument input with high impedance and low noise.
The high-impedance ALTERNATIVE INPUT is located on the rear panel. You may
find it useful in rack setups, either for connecting the instrument directly, or through
a wireless receiver. It is a bit noisier than the Front INPUT, but this is only an issue
for guitars with a soft output level, applied to heavy distortion.
Even when Input Source is set to "Alternative Input", it won't work when a cable is
still connected to the Front INPUT.
You can still use mono effect loops when using the ALTERNATIVE INPUT, but avoid
using the stereo effect loop; it uses the ALTERNATIVE INPUT as the right return
input for the loop, and the Profiler does not automatically compensate for this
situation.
Return Input can be chosen as an analog, studio-level input for reamping purposes.
The balanced TRS or the XLR inputs are available as the RETURN INPUT.
The S/PDIF INPUT is typically used for reamping from an audio interface. S/PDIF
signals are stereo by definition, however only the left side is taken for reamping.
If no S/PDIF cable is connected, or no S/PDIF sync signal is detected, the FRONT
INPUT is still active.
Both the RETURN INPUT and S/PDIF INPUT do not respond to the settings of
Clean Sens and Distortion Sens. They have their dedicated control Reamp Sens.
GETTING STARTED 17