Gain Knob; Input Button - Kemper PROFILER Bedienungsanleitung

16 KEMPER PROFILER
If you press STORE when you have an Effects Module in focus, you are given the option to save either the set-
tings of the currently selected Module as a Module Preset, or to save the entire Rig. Choose soft button #1 to cre-
ate a new Module Preset and to dial in an appropriate name.
Your Preset can be found and reloaded later by turning BROWSE, when you have a similar effect in focus.
(10)

Gain Knob

The GAIN knob controls the amount of distortion, and covers an extremely wide range from ultra-clean to totally
distorted. The Gain control allows for the same large range on all Profiles, even if the original amp has a more
limited gain range. The "Gain" parameter compensates for the loss in level with any amount of gain reduction.
You can turn the gain value to zero for every Amp Profile, and the result will be a totally undistorted and uncom-
pressed sound that has the same perceived loudness as the fully distorted version.

Input Button

Press this button to enter the Input Section. Here, you can set the input sensitivity and select the physical input
for your guitar signal. The Noise Gate, with its dedicated knob, also belongs to the Input Section.
Clean Sens
♦
Extremely "hot" guitars can generate unwanted distortion, indicated by the Input LED flashing red. This is only
relevant for clean sounds, however - prominent amp distortion will fully mask a subtle clipping of the input. You
can verify this fact by trying different settings of Clean Sens. However, if you want to avoid a red input LED, you
can always lower Clean Sens.
Distortion Sens
♦
If you feel that your guitar tends to drive the distortion too hot (or too soft) for the majority of Factory Rigs, cali-
brate your guitar by adjusting Distortion Sens accordingly. At zero (middle) position, every Rig will react as if you
have plugged your guitar to the original amplifier. For individual adjustments of gain, use the Gain knob, as usual.
(11)