Stomps; Stack - Kemper PROFILER Bedienungsanleitung

GETTING STARTED 11
Once you have found a Rig that you like, you can use the soft knobs underneath the display to change the gain
and the eq of the Rig. These controls display their current value on the LED collar around the knobs.

Stomps

The first Section, labeled "STOMPS", is for your stomp box effects. This Section offers four Stomp Modules which
are represented by the four buttons labeled A, B, C, and D. Here you can place the built-in stomp effects in any
order and configuration you like. These effects are applied before the signal reaches the Stack Section.
Stomp Type LED Color Coding
♦
You will notice that the stomp LEDs aren't simply lit or unlit, but have many different colors. That's because these
LEDs use color to help identify which Stomp type is being used. By rotating the TYPE knob above the left side of
the display you can choose the effect type for a stomp currently shown in the display. The BROWSE knob above
the right side of the display can be used to select from a list of "Stomp Presets". Stomp Presets are settings for a
specific stomp type, and are stored independently from the Rig itself.
Finally, you can select more stomps and effects in the Effects Section, and change the settings of Delay and Re-
verb using their dedicated knobs.

Stack

In the middle of this signal flow, you will find the "Stack" Section with the buttons for Amplifier, EQ (equalizer)
and Cabinet. The Stack Section represents the raw, virtual guitar amplifier and cabinet, as defined by the Profile.
In the Stack Section, you can freely combine amps and cabinets by holding their respective buttons to bring
them into focus, and then scrolling through the available Amplifier and Cabinet Presets with the BROWSE knob.