Using The Tuner; Building A Rig - Kemper PROFILER Bedienungsanleitung

Using the Tuner

The tuner LEDs above the chicken-head knob are always active, so you can monitor your tuning while you play.
Even when you're not in tuning mode, the LEDs give you general information whether your guitar is in tune or
not. If a guitar string is far out of tune, only the outer LEDs will be on. If your string is closer to proper tuning, the
middle LED gets brighter. If your string is in tune, only the middle LED will be lit. So, to tune your strings, make
sure that the white LED in the middle is on, and the surrounding green LEDs are both off. If you want a far more
advanced tuner, you can use the chicken-head knob to activate Tuner Mode. While Tuner Mode is engaged, a
large tuner graphic appears, and additional, unique tuner functions become available:
MUTE SIGNAL This determines whether the audio is sent to the MASTER OUTPUTS or not. To tune your
guitar silently, enable "Mute Signal". The signal will then be muted, but only while you're
in Tuner Mode. This is a neat way to mute the signal temporarily; for example, to avoid
unwanted noise when you change guitars.
MASTER TUNE Use "Master Tune" to adjust the base pitch of the tuner, in case you need to tune your
guitar to something other than 440 Hz.
When the Tuner Mode is enabled, the LEDs become more sensitive to softer levels.

Building a Rig

If you have ever used a digital guitar processor before, you will know that building your own Rigs is part of the
fun! You will find it surprisingly easy to do in the Profiler. Simply bring any Module or Section into focus, activate
it, and select from a range of Module and Section Presets using the BROWSE knob. Tweak to your liking, add
spices if necessary. To help get you started, here is a brief overview of the available Modules:
USING THE TUNER 25