Connecting Gear; Choosing Rigs - Kemper PROFILER Bedienungsanleitung

10 KEMPER PROFILER

Connecting Gear

The Profiler is equipped with a studio-grade, analog input-stage, followed by a state-of-the-art A/D stage for the
best possible sound. Once your guitar signal has been processed, the high-quality D/A stage ensures that you get
the best sound quality back out again. You will notice there are multiple inputs and outputs in both analog and
digital formats, which we will describe in more detail down below. We included all this connectivity so you can
use the Profiler as a central hub in your studio, allowing you to connect your guitar to a variety of other amps, ef-
fects and recording gear, and switch between them easily. In case you have any hum-related issues in your studio
or on stage, we provide ground-lift switches for the analog outputs.

Choosing Rigs

A complete signal chain is called a "Rig". The signal flow begins with the Input Section, passes through the
Stomps, Stack, and Effects Sections at the top of the front panel, and finally, the Output Section. The order of
the Sections from left to right represents the signal flow inside the Profiler. Each Section consists of three to four
"Modules".
Each of the buttons in the signal flow gives you a unique and intuitive way to manage your sound. By pressing a
corresponding button, you activate each Module or Section. Holding the button a little bit longer will focus the
Module and show its parameters in the display. In the lower line of the display you see up to four parameters that
can be controlled by the soft knobs underneath. Tweak the knobs to change your sound. If this Module offers
more than four parameters, you can navigate between pages using the PAGE buttons. If you want to return to the
main page, press EXIT.
If you changed a parameter setting, but want to return to the previous value, you can use the UNDO button on
the left side of the display. It will always revert your most recent action. The REDO button will revert the action of
the UNDO button.
In Browse Mode, you can select the desired Rig using the RIG buttons on the right side of the front panel. The
left and right buttons of the RIG navigation cross will advance in single steps, while the up and down buttons will
change Rigs in larger steps. You can also use the BROWSE knob above the right side of the display to see eight
Rigs simultaneously, as well as scroll through the list of all available Rigs. You can change the sequence of Rigs by
using the soft button "Sorted by ..." to sort them by date or author, and then load the selected Rig with soft but-
ton "Load".