Abicor Binzel iCAT mini ABIROB G Serie Betriebsanleitung Seite 48

11 Disassembly
11.1 Standard model
11.2 Model with wire brake
EN - 24
NOTICE
• Disassembly must only be carried out by qualified personnel
(in Germany, see TRBS 1203).
• Consult the operating instructions for the following welding components:
robot welding power source and welding torch.
• Observe the information provided in the following section:
 8 Decommissioning on page EN-19
1 Disconnect the cable assembly from the wire feeder.
 Fig. 5 Maintenance position of the robot on page EN-12
®
Versions ABIROB G350:
2 Remove protective cap (1) and bellows (5), loosen cylinder head
screw (6).
 Fig. 10 Attaching the ABIROB
3 Disconnect the torch neck and remove it.
 7 Operation on page EN-19
4 Disassemble the iCAT mini (1) from the robot (7).
 Fig. 6 Attaching the iCAT mini to the robot on page EN-13
1 Disconnect the cable assembly from the wire feeder.
2 Remove the protective cap (1).
3 Pull the plastic tube (4) out of the wire brake (3).
4 Unscrew the wire brake (3).
5 Pull off the bellows (2) over the torch neck.
 Fig. 13 Cleaning—model with wire brake on page EN-21
6 Loosen the mounting screw (6).
 Fig. 10 Attaching the ABIROB
7 Disconnect the torch neck and remove it.
 7 Operation on page EN-19
8 Disassemble the iCAT mini (1) from the robot (7).
 Fig. 6 Attaching the iCAT mini to the robot on page EN-13
®
torch neck on page EN-17
®
torch neck on page EN-17
BAL.0361.0 • 2017-05-05
iCAT mini