Troubleshooting - Abicor Binzel iCAT mini ABIROB G Serie Betriebsanleitung

iCAT mini
9.2 Model with wire brake
1
1 Protective cap
2 Bellows
Fig. 13 Cleaning—model with wire brake

10 Troubleshooting

BAL.0361.0 • 2017-05-05
We recommend cleaning the iCAT mini with wire brake 1–2 times weekly.
2 3
3 Wire brake
4 Plastic tube
1 Remove the protective cap (1).
2 Pull the plastic tube (4) out of the wire brake (3).
3 Unscrew the wire brake (3).
4 Pull off the bellows (2) over the torch neck.
5 Clean exposed parts with compressed air.
6 Remount the bellows (2), wire brake (3) and protective cap (1).
DANGER
Risk of injury and device damage when handled by
unauthorized persons
Improper repair work and modifications to the product may lead to serious
injuries and damage to the device. The product warranty will be rendered
invalid if work is carried out on the product by unauthorized persons.
• Operating, maintenance, cleaning, fault and repair work may only be
carried out by qualified personnel (in Germany, see TRBS 1203).
Observe the attached "Warranty" document. Contact your retailer or the
manufacturer if you have questions and/or problems.
NOTICE
• Also consult the operating instructions for the welding components, such
as the power source, welding torch system, coolant recirculator etc.
4
5
10 Troubleshooting
5
iCAT mini without bellows
and protective cap
EN - 21