Magic Vac P0608ED Betriebsanleitung Seite 41

• Make sure the Sealing Bar(6), the Airtight Gasket (7) and Sealing Gasket (9) are
• The MAGIC VAC
• When you can't completely seal the bag, press the "sealing mode" button (2M)
• If the Sealing Bar (6) overheats and melts the bag, lift the Cover (5) and allow the
®
MAGIC VAC does not
correctly seal the bag
• Check the position and integrity of the Sealing Gasket (9)
• If liquids escape during the vacuum-packing phase, remember that they must first
• Leaks along the seal can be caused by wrinkles, crumbs, grease or liquids. Open
The MAGIC VAC ® bag
doesn't maintain its
• Make sure the bag is not punctured and thus did not maintain the vacuum. Protect
vacuum after sealing
• Using the Canister Tube (16), connect the canister lid (or the Lid Attachment if
• Leave adequate space (at least 3 cm) between the contents and the top of the jar
®
MAGIC VAC does not
• Make sure that the rim of the jar or canister and universal lid are not damaged in
seal containers.
• Make sure the gasket on the canister lid or universal lid is placed in the correct
• Make sure the knob on the canister lid is set to "VACUUM" before vacuum-packing
• Check that the O-Ring under the knob on the canister lid or universal lid is correctly
MAGIC VAC ® Executive
• Makes sure that the rim of the jar or canister and universal lid are not damaged in
canisters or Universal
MAGIC VAC ® Lids do
• Make sure the gasket on the canister lid or universal lid is placed in the correct
not maintain the seal
• Make sure the connection tube is correctly connected to both the canister knob as
• Make sure the knob on the lid of the Square MAGIC VAC
• Check that the O-Ring under the knob on the canister lid or universal lid is correctly
• Makes sure that the rim of the jar or canister and universal lid are not damaged in
The marinating cycle
• Make sure the connection tube is correctly connected to both the canister knob as
does not start correctly
• Make sure the gasket on the canister lid or universal lid is placed in the correct
• Lightly press the canister lid down when the first vacuum phase starts until the
not dirty.
®
bag may be punctured. To check, seal the bag with air inside,
place it under water and squeeze. If you see bubbles, there is a leak. Reseal or
use another bag.
and increase the sealing time.
Sealing Bar (6) to cool for a few minutes.
be refrigerated.
the bag, clean the upper part of the inside of the bag and remove any residue from
the Sealing Bar (6) before resealing.
any pointed edges of the contents in the bag using paper napkins.
necessary) and the ACCESSORY PORT (4) on the machine.
or canister.
the sealing zone. Clean the rim and the lid with a damp cloth and reseal.
position and not damaged.
and that it is set to "CLOSED" after it is complete.
positioned.
the sealing zone. Clean the rim and the lid with a damp cloth and reseal.
position and not damaged.
well as the ACCESSORY PORT (4) on the machine.
ACO1073) is set to "OPEN - (M)" and that the Handles (1) are attached.
positioned.
the sealing zone. Clean the rim and the lid with a damp cloth and reseal.
well as the ACCESSORY PORT (4) on the machine.
position and not damaged.
lights on the Progress Display (2C) are regularly lit.
40
®
Executive Canister (cod.