Before First Use - Klarstein STEAKREAKTOR 2.0 Bedienungsanleitung

Unpacking
1. Take the unit and accessories out of the box.
2. Keep the two wrapping cartons and the enclosed padding for the steak reactor. Only with this special pa-
ckaging a safe transport is possible in case of complaint.
3. Remove the remaining accessories from the interior of the grill.
4. Carefully remove all packaging and check that the the interior is free from packaging material. Check the
appliance and especially the heating element and cable for damage.
Delivery
Check that the delivery is complete and inspect all parts for any damage.
If anything is missing or damaged, please immediately contact our customer service. The following parts are
included with delivery:
High temperature grill
Grill grate
Guide handle for the grate
Grease drip tray
Grill insert
Set up
When setting up, ensure that there is a sufficient distance between the device and strong heat sources such
as hot plates, heating tubes, etc.
Avoid heat build-up and place the unit in an area that allows heat occurring during use of the device to dissipate.
The minimum distance on the sides of the device must be at least 15 cm. Above, there must be a minimum
distance of 50 cm. The feet also serve as spaces underneath the device.
During the first use, smoke and odours may result from the burning of care oils. Therefore heat the device
while it is empty (without food) for about 10 minutes in a well-ventilated room with the grill and drip tray
intact.
Do not place the device under a wall cabinet or in a corner. Keep a safe distance from flammable materials
such as curtains or tablecloths.
Set the appliance on a stable, flat, heat-resistant surface.
Cleaning
Before first use, you should clean the appliance carefully to remove dust and possible packaging and produc-
tion residues. Afterward, heat the grill without food and clean again.
1. Clean all of the accessories in warm dishwater. Dry the parts thoroughly. Note that aggressive cleaning
agents can cause corrosion, even on stainless steel.
2. Clean the outside and inside of the grill with a soft cloth slightly dampened with water.
3. Rub the oven thoroughly to dry.
4. Plug the power cord into a socket with protective contact.
21

Before first Use