Operation - Cameo AURO BEAM 200 DC Bedienungsanleitung

6
ILLUMINATED LC DISPLAY
The LCD display shows the currently activated mode (main display), the menu items in the selection menu and the numerical value or operating
mode in certain menu items. If there is no input for approx. one minute, the display automatically returns to the main display. If there is no
control signal at the DMX input, the colour of the display changes to red (DMX and slave operation).
7
TOUCH-SENSITIVE CONTROLS
MODE – Press MODE to access the selection menu. Press again to return to the main display.
ARROW and  – Select individual menu items in the selection menu (DMX address, operating mode etc.) and in the sub-menus.
ENTER – In the selection menu, press ENTER to access the menu level in which values can be changed. Confirm value changes by pressing
ENTER.
ARROW  and  – use thEse buttons to alter the value of a menu item, e.g. DMX address.
The battery-powered display can be activated, even if the device is not connected to the mains. To do this, press and hold MODE for
approximately 3 seconds. You can now access device information and change and save system settings without mains connection. The DMX
unit of the spotlight is not activated in this case. For this reason, even if a DMX signal is present at the DMX input, the display shows that no
DMX signal is present.

OPERATION

TIPS
When the spotlight is correctly connected to the mains, the following message is displayed during the boot process and the motor reset
process:"Software Update Please Wait..." (only for service purposes) and the Cameo logo appears in the display. After this process, the
spotlight is ready for operation and the previously selected mode will be activated. If the lamp has not cooled down sufficiently, it may take
a few minutes before the light is ready for operation again. For information, "Lamp not ready, please wait" appears in the main display in
red letters.
MAIN DISPLAY (DMX MODE)
The DMX mode (DMX 13ch, DMX 16ch) is shown in the top line of the display and the DMX start address is clearly visible in the centre of the
display. If the DMX signal is interrupted, the background colour of the display turns red and "No DMX" is displayed. If the DMX signal returns, the
display returns to the main display. The display can be rotated 180° by pressing the right arrow key (lights in a standing position).
DMX 16Ch
001
Press mode to navigate
MAIN DISPLAY (STANDALONE MODE)
"Operating Mode" is shown in the top line of the display and the standalone mode is clearly visible in the centre (e.g. Static). The display can be
rotated 180° by pressing the right arrow key (lights in a standing position).
Operating Mode
Static
Press mode to navigate
6
6
7