Cameo AURO BEAM 200 DC Bedienungsanleitung Seite 10

P/T Macro 000
(Pan/Tilt
006
macro)
041
076
111
146
181
216
P/T speed 000
(Pan/Tilt
speed)
DEVICE SETTINGS (Settings)
Press MODE to access the selection menu. Using  and , select the menu item "Settings" (dark background) and confirm with ENTER.
System Settings
DMX Address 001
Mode DMX 16CH
Settings
System Info
This will take you to the submenu for setting the following submenu items (adjust setting with  and  and confirm with ENTER):
Settings
Lamp =
Lamp default =
Display Rev =
Display =
DMX Fail =
Pan Angle =
Pan Rev =
Tilt Rev =
Feedback =
Mov Blackout =
10
– 005 off
– 040 PAN small > big
– 075 TILT small > big
– 110 PAN/TILT small > big
– 145 PAN/TILT (inverse) small > big
– 180 Circle small > big
– 215 Circle (inverse) small > big
– 255 Random small > big
– 255 Pan/Tilt Fast -> Slow
Switch on/off of the On
discharge lamp
Off
Operating status of the On
discharge lamp after
Last
restart of spotlight
Off
Flip display On
Off
Display lighting On
Off
Operating status with Hold
DMX signal fault
Auto
Blackout
Pan angle 630
540
Pan reverse On
Off
Tilt Reverse On
Off
Position correction On
Off
Automatic blackout On
during head movement
Off
Switch on discharge lamp
Switch off discharge lamp
Discharge lamp switched on
Returns to status prior to restart
Discharge lamp switched off
Rotate display by 180° (e.g. for overhead installation)
No display rotation
On permanently
Deactivation after approximately 1 minute of inactivity
Last command is retained
activates Auto mode
Activates blackout
Pan angle 630°
Pan angle 540°
reverses pan direction
do reverse of pan direction
reverses tilt direction
does not reverse tilt direction
Automatic position correction is enabled
Automatic position correction is disabled
Blackout during head movement
No blackout during head movement