System Settings - Cameo AURO BEAM 200 DC Bedienungsanleitung

SETTING DMX START ADDRESS (DMX ADDRESS)
Press MODE to access the selection menu. Using  and , select the menu item "DMX Address" (coloured background) and confirm with
ENTER. The 3 digits indicating the DMX start address change colour to red. Use  and  to configure the required DMX address. Confirm
the entry with ENTER and press MODE to return to the main display.

System Settings

DMX Address 001
Mode DMX 16CH
Settings
System Info
SETTING OPERATING MODE (Mode)
Press MODE to access the selection menu. Using  and , select the menu item "Mode" (dark background) and confirm with ENTER. The
characters showing the operating mode (in the example DMX 16CH), change colour to red and using  and , you can select the desired
mode. Confirm the entry with ENTER and press MODE to return to the main display. Available operating modes: DMX 13CH, 16CH, Slave,
Auto, Static.
System Settings
DMX Address 001
Mode DMX 16CH
Settings
System Info
DMX MODE (DMX)
Two different DMX operating modes are available for selection: 13-channel and 16-channel (DMX 13CH, 16CH). Selection of DMX mode is
as described previously in SETTING OPERATION MODE. Tables with the channel assignments can be found in these instructions under DMX
CONTROL.
Mode DMX 16CH
SLAVE MODE (Slave)
Selection of Slave mode is as described previously in SETTING OPERATION MODE. Connect the slave and the master unit (same model) with
a DMX cable (Master = DMX OUT, Slave = DMX IN) and enable one of the standalone modes on the master unit (Auto or Static). Now the
slave unit will follow the master unit.
Mode Slave
AUTO MODE (Prog 1–Prog 4)
Each of the 2 available auto programmes consist of a sequence of pre-configured colour change, gobo change and motion sequences.
Selection of Auto mode is as described previously in SETTING OPERATION MODE. Use  and to select the menu item "Auto" and confirm
with ENTER. Use  and  to select one of the four automatic programmes (Prog 1–Prog 4), confirm with ENTER and use  and  to
select the menu item "AutoSpeed" to set the programme run speed. Press ENTER and use and to set the speed between 000 and 255
(000 = fastest, 255 = slowest speed). Confirm the process with ENTER and press MODE twice to return to the main display.
Mode Auto
Auto Mode
Auto Prog4
AutoSpeed 225
STATIC MODE (Static)
The static mode allows all functions and effects such as Pan, Tilt, Colour, Gobo wheel and Strobe to be adjusted directly on the device with val-
ues between 000 and 255, in a similar way to with a DMX controller. In this way, an individual scene can be created without an additional DMX
controller. Selection of Static mode is as described previously in SETTING OPERATION MODE. After confirming with ENTER, you can now activate
the functions and effects with the  and  keys (see list). Press ENTER. The value can now be adjusted using  and . Always confirm
entries with ENTER. After all the functions and effects have been set as desired, press MODE twice to return to the main display.
Mode Static
7