System Info - Cameo AURO BEAM 200 DC Bedienungsanleitung

Test = Function test
Reset = Reset motors
DEVICE INFORMATION (System Info)
Press MODE to access the selection menu. Using  and , select the menu item "System info" (coloured background) and confirm with ENTER.
System Settings
DMX Address 001
Mode DMX 16CH
Settings

System Info

This will take you to the sub-menu for displaying device information. Use the arrow keys to select the desired parameter and then retrieve
and/or configure with ENTER.
System Info
Firmware = Displays device firmware
Temperature = Displays temperature of LED unit
Time Info = Displays operating time of spotlight and
operating time of lamp plus reset
Error Info = Function error display
If a fault is not corrected by a reset or
restart, the defective unit must be re-
paired by an authorised service centre.
On Step-by-step function test of the discharge lamp and all motors
(Pan, Tilt, Gobo...)
Off Stop function test
Pan&Tilt resets the pan & tilt motors
Head Resets all head motors (colour wheel, gobo wheel, prism...)
All Reset all motors
1U01 V1.xx
2U01 V1.xx
3U01 V1.xx
Lamp Temp xxC / xxF
Temp Unit Celsius (= display in degrees Celsius)
Fahrenheit (= display in degrees Fahrenheit)
Operating Displays the operating time of the spotlight in hours
(Xxh)
Lamp Displays the operating time of the lamp in hours (Xxh)
Lamp Reset Resets the operating time to zero hours after replace-
ment of the lamp (on -> ENTER)
PAN Solution: Reset Pan&Tilt
TILT Solution: Reset Pan&Tilt
Fixgobo Solution: Reset head
Focus Solution: Reset head
Prism1 Solution: Reset head
PrismRot1 Solution: Reset head
Prism2 Solution: Reset head
PrismRot2 Solution: Reset head
Frost Solution: Reset head
Fan1 Automatic shut-off of lamp (blackout)
Display shows: "Lamp Protected"
Solution: Restart the device
Fan2 Automatic shut-off of lamp (blackout)
Display shows: "Lamp Protected"
Solution: Restart the device
Blower Automatic shut-off of lamp (blackout)
Display shows: "Lamp Protected"
Solution: Restart the device
Temperature Automatic shut-off of lamp (blackout)
Display shows: "Lamp Protected"
Solution: Wait until normal operating temperature is
achieved (allow to cool). Ignite lamp manually
11